Passenger Squib 2 Circuit Short - Chrysler Town and Country 2003 Owner's Manual

AIRBAG
Symptom:

PASSENGER SQUIB 2 CIRCUIT SHORT

When Monitored and Set Condition:
PASSENGER SQUIB 2 CIRCUIT SHORT
When Monitored: With the ignition on, the ACM monitors the resistance between the
Passenger Squib 2 circuits.
Set Condition: When the ACM detects low resistance in the Passenger Squib 2 circuits.
PASSENGER AIRBAG SQUIB 2 CIRCUIT SHORT
PASSENGER SQUIB 2 LINE 1 SHORT TO LINE 2
ACM, PASSENGER SQUIB 2 CIRCUIT SHORT
STORED CODE OR INTERMITTENT CONDITION
ACTIVE CODE PRESENT
TEST
1 Turn the ignition on.
NOTE: Ensure the battery is fully charged.
NOTE: For the purpose of this test, the AECM and ORC modules will be
referred to as an ACM.
SELECT ACTIVE or STORED DTC:
ACM - ACTIVE DTC
ACM - STORED DTC
NOTE: When reconnecting Airbag system components, the ignition must be
turned off and the battery must be disconnected.
2 WARNING: TURN THE IGNITION OFF, DISCONNECT THE BATTERY AND
WAIT TWO MINUTES BEFORE PROCEEDING.
Disconnect the Passenger Airbag connector(s).
NOTE: Check connectors - Clean and repair as necessary.
WARNING: DO NOT PLACE AN INTACT UNDEPLOYED AIRBAG FACE
DOWN ON A HARD SURFACE, THE AIRBAG WILL PROPEL INTO THE AIR
IF ACCIDENTALLY DEPLOYED, AND COULD RESULT IN SERIOUS OR
FATAL INJURY.
Connect the appropriate Load Tool to the Passenger Airbag connector(s).
WARNING: TURN THE IGNITION ON, THEN RECONNECT THE BATTERY.
With the DRBIII , read the active Airbag Control Module DTC's.
Does the DRBIII show PASSENGER SQUIB 2 CIRCUIT SHORT?
Yes → Go To 3
→ Replace Passenger Airbag in accordance with the Service Infor-
No
POSSIBLE CAUSES
ACTION
Go To 2
Go To 4
mation.
Perform AIRBAG VERIFICATION TEST - VER 1.
150
APPLICABILITY
All
All