Chrysler Town and Country 2003 Owner's Manual page 95

DRIVER SQUIB 1 SHORT TO BATTERY —
TEST
2 WARNING: TURN THE IGNITION OFF, DISCONNECT THE BATTERY AND
WAIT TWO MINUTES BEFORE PROCEEDING.
Disconnect the Driver Airbag Squib connector(s).
WARNING: DO NOT PLACE AN INTACT UNDEPLOYED AIRBAG FACE
DOWN ON A HARD SURFACE, THE AIRBAG WILL PROPEL INTO THE AIR
IF ACCIDENTALLY DEPLOYED, AND COULD RESULT IN SERIOUS OR
FATAL INJURY.
NOTE: Check connectors - Clean and repair as necessary.
Connect the appropriate Load Tool to the Driver Airbag connector(s).
WARNING: TURN THE IGNITION ON, THEN RECONNECT THE BATTERY.
With the DRBIII , read the active Airbag Control Module DTC's.
Does the DRBIII show DRIVER SQUIB 1 SHORT TO BATTERY?
Yes → Go To 3
No
3 WARNING: TURN THE IGNITION OFF, DISCONNECT THE BATTERY AND
WAIT TWO MINUTES BEFORE PROCEEDING.
Disconnect the Load Tool from the Driver Airbag connector(s).
Disconnect the Clockspring connector(s).
NOTE: Check connectors - Clean and repair as necessary.
Connect the appropriate Load Tool to the Clockspring connector(s).
WARNING: TURN THE IGNITION ON, THEN RECONNECT THE BATTERY.
With the DRBIII , read the active Airbag Control Module DTC's.
Does the DRBIII show DRIVER SQUIB 1 SHORT TO BATTERY ?
Yes → Go To 4
No
4 WARNING: TURN THE IGNITION OFF, DISCONNECT THE BATTERY AND
WAIT TWO MINUTES BEFORE PROCEEDING.
WARNING: IF THE AIRBAG CONTROL MODULE IS DROPPED AT ANY
TIME, IT MUST BE REPLACED.
Disconnect the Load Tool from the Clockspring connector(s).
Disconnect the Airbag Control Module connector(s).
NOTE: Check connectors - Clean and repair as necessary.
Connect the appropriate Load Tool Adaptor to the Airbag Control Module connec-
tor(s).
WARNING: TURN THE IGNITION ON, THEN RECONNECT THE BATTERY.
Measure the voltage on the Driver Squib 1 Line 1 and Line 2 circuits between the
Clockspring connector and ground.
Is there any voltage present?
Yes → Repair the Driver Squib 1 Line 1 or Line 2 circuits shorted to
No
ACTION
→ Replace the Driver Airbag in accordance with the Service Infor-
mation.
Perform AIRBAG VERIFICATION TEST - VER 1.
→ Replace the Clockspring in accordance with the Service Informa-
tion.
Perform AIRBAG VERIFICATION TEST - VER 1.
battery.
Perform AIRBAG VERIFICATION TEST - VER 1.
→ WARNING: MAKE SURE THE BATTERY IS DISCONNECTED,
THEN WAIT TWO MINUTES BEFORE PROCEEDING. Replace
the Airbag Control Module in accordance with Service Informa-
tion.
Perform AIRBAG VERIFICATION TEST - VER 1.
Continued
71
AIRBAG
APPLICABILITY
All
All
All