Chrysler Town and Country 2003 Owner's Manual page 172

AIRBAG
PASSENGER SQUIB 2 CIRCUIT OPEN —
TEST
2 WARNING: TURN THE IGNITION OFF, DISCONNECT THE BATTERY AND
WAIT TWO MINUTES BEFORE PROCEEDING.
Disconnect the Passenger Airbag connector(s).
NOTE: Check connectors - Clean and repair as necessary.
WARNING: DO NOT PLACE AN INTACT UNDEPLOYED AIRBAG FACE
DOWN ON A HARD SURFACE, THE AIRBAG WILL PROPEL INTO THE AIR
IF ACCIDENTALLY DEPLOYED, AND COULD RESULT IN SERIOUS OR
FATAL INJURY.
Connect the appropriate Load Tool to the Passenger Airbag connector(s).
WARNING: TURN THE IGNITION ON, THEN RECONNECT THE BATTERY.
With the DRBIII , read the active Airbag Control Module DTC's.
Does the DRBIII show PASSENGER SQUIB 2 CIRCUIT OPEN?
Yes → Go To 3
→ Replace the Passenger Airbag in accordance with the Service
No
3 WARNING: TURN THE IGNITION OFF, DISCONNECT THE BATTERY AND
WAIT TWO MINUTES BEFORE PROCEEDING.
Disconnect the Load Tool from the Passenger Airbag connector(s).
Disconnect the Airbag Control Module connector(s).
NOTE: Check connectors - Clean and repair as necessary.
Connect the appropriate Load Tool adaptor to the Airbag Control Module connec-
tor(s).
Measure the resistance of the Passenger Squib 2 Line 1 and Line 2 circuits between
the ACM Adaptor and the Passenger Airbag connector.
Is the resistance below 1.0 ohms on both circuits?
Yes → Replace the Airbag Control Module in accordance with Service
→ Repair open or high resistance in Passenger Squib 2 Line 1 or
No
ACTION
Information.
Perform AIRBAG VERIFICATION TEST - VER 1.
Information. WARNING: IF THE AIRBAG CONTROL MODULE
IS DROPPED AT ANY TIME, IT MUST BE REPLACED.
Perform AIRBAG VERIFICATION TEST - VER 1.
Line 2 circuits.
Perform AIRBAG VERIFICATION TEST - VER 1.
Continued
148
APPLICABILITY
All
All