POWER MIRROR
*DRIVER FOLDING MIRROR DOES NOT FOLD (EXPORT ONLY) —
Continued
TEST
4
Disconnect the inoperative Power Mirror connector.
Disconnect the Body Control Module C2 connector.
NOTE: Check connectors - Clean/repair as necessary.
Measure the Driver Folding Mirror Fold Driver circuit from the BCM C2 connector
to the mirror harness connector.
Is the resistance below 5.0 ohms?
Yes → Replace the Body Control Module.
→ Repair the Driver Folding Mirror Fold Driver circuit for an open.
No
ACTION
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
942
APPLICABILITY
All