Left Front Turn Signal Output Short - Chrysler Town and Country 2003 Owner's Manual

EXTERIOR LIGHTING
Symptom:

LEFT FRONT TURN SIGNAL OUTPUT SHORT

When Monitored and Set Condition:
LEFT FRONT TURN SIGNAL OUTPUT SHORT
When Monitored: Ignition and left turn signal On.
Set Condition: When output voltage status is Low.
INTERMITTENT CONDITION
LEFT FRONT TURN SIGNAL OUTPUT SHORT TO GROUND
TURN SIGNAL LAMP
BODY CONTROL MODULE
TEST
1 Turn the ignition on.
With the DRBIII , clear all BCM DTC's.
Actuate the Turn Signals.
With the DRBIII , read the DTC information.
Does the DRBIII read: Left Front Turn Signal Output Short?
Yes → Go To 2
→ The condition that caused the symptom is currently not present.
No
2 Turn the ignition off.
Disconnect the Left Front Turn Signal Lamp connector.
Disconnect the BCM C2 harness connector.
Measure the resistance between the Left Front Turn Signal Output circuit and
ground.
Is the resistance below 100.0 ohms?
Yes → Repair the Left Front Turn Signal Output circuit for a short to
→ Go To 3
No
POSSIBLE CAUSES
ACTION
Inspect the related wiring for a possible intermittent condition.
Look for any chafed, pierced,pinched, or partially broken wires.
Perform BODY VERIFICATION TEST - VER 1.
ground.
Perform BODY VERIFICATION TEST - VER 1.
456
APPLICABILITY
All
All