Eps" Warning Light Check; Dtc Check - Suzuki Swift Sport 2004 Service & Repair Manual

6C-8 Power Assisted Steering System:
Step 2: DTC Check, Record and Clearance
First, check DTC, referring to "DTC Check". If DTC is
indicated, print it or write them down and then clear them
by referring to "DTC Clearance". DTC indicates
malfunction that occurred in the system but does not
indicate whether it exists now or it occurred in the past
and the normal condition has been restored now. To
check which case applies, check the symptom in
question according to Step 5 and recheck DTC
according to Step 6 and 7.
Attempt to diagnose a trouble based on DTC in this step
only or failure to clear the DTC in this step will lead to
incorrect diagnosis, trouble diagnosis of a normal circuit
or difficulty in troubleshooting.
Step 3 and 4: Visual Inspection
As a preliminary step, be sure to perform visual check of
the items that support proper function of the P/S system
referring to "Visual Inspection".
Step 5: Trouble Symptom Confirmation
Based on information obtained in "Step 1: Customer
Complaint Analysis: " and "Step 2: DTC Check, Record
and Clearance: ", confirm trouble symptoms. Also,
reconfirm trouble symptom by performing test drive and
turning steering wheel fully to right and left at stopped
vehicle.
Step 6 and 7: Rechecking and Record of DTC
Refer to "DTC Check" for checking procedure.
Step 8: Steering Symptom Diagnosis and P/S
System Symptom Diagnosis
Perform basic steering system check according to
"Steering Symptom Diagnosis in Section 6A" first. When
the end of the flow has been reached, check the parts of
the system suspected as a possible cause referring to
"P/S System Symptom Diagnosis" and based on
symptoms appearing on the vehicle (symptoms obtained
through steps of customer complaint analysis, trouble
symptom confirmation and/or basic P/S system check)
and repair or replace faulty parts, if any.
Step 9: Troubleshooting for DTC (See each DTC
Diag. Flow)
Based on the DTC indicated in Step 6 or 7 and referring
to the applicable DTC diag. flow, locate the cause of the
trouble, namely in a sensor, switch, wire harness,
connector, actuator, P/S control module or other part and
repair or replace faulty parts.
Step 10: Intermittent Problems Check
Check parts where an intermittent trouble is easy to
occur (e.g., wire harness, connector, etc.), referring to
"Intermittent and Poor Connection Inspection in Section
00" and related circuit of DTC recorded in Step 2.
Step 11: Final Confirmation Test
Confirm that the problem symptom has gone and the P/
S system is free from any abnormal conditions. If what
has been repaired is related to the DTC, clear the DTC
once, perform DTC confirmation procedure and confirm
that no DTC is indicated.

"EPS" Warning Light Check

1) Turn ignition switch to ON position (without engine
running) and check if the "EPS" warning light (1)
lights up. If the light dose not light up, go to ""EPS"
Warning Light Does Not Come ON with Ignition
Switch Turned ON before Engine Starts" of the
diagnostic flows.
2) Start engine and check if the "EPS" warning light
turns OFF. If light remains ON and no DTC is stored
in P/S control module, go to ""EPS" Warning Light
Remains ON Steady after Engine Starts" for
troubleshooting.

DTC Check

1) Turn ignition switch to OFF position.
2) Connect SUZUKI scan tool to data link connector
(DLC) (1) located on underside of instrument panel
at driver's seat side.
Special tool
(A): SUZUKI scan tool
(A)
S7RS0B6304002
1
I6RS0C630002-01
S7RS0B6304003
1
I4RS0B450003-01