Battery Dismounting And Remounting; Water Pump / Generator Drive Belt Tension Inspection And Adjustment - Suzuki Swift Sport 2004 Service & Repair Manual

With Charging Equipment
CAUTION
!
When jump starting engine with charging
equipment, be sure equipment used is 12-
volt and negative ground. Do not use 24-volt
charging equipment. Using such equipment
can cause serious damage to electrical
system or electronic parts.

Battery Dismounting and Remounting

WARNING
!
When handling battery, following safety
precautions should be followed:
• Hydrogen gas is produced by battery. A
flame or spark near battery may cause the
gas to ignite.
• Battery fluid is highly acidic. Avoid spilling
on clothing or other fabric. Any spilled
electrolyte should be flushed with large
quantity of water and cleaned immediately.
Dismounting
1) Disconnect negative cable (1).
2) Disconnect positive cable (2).
3) Remove retainer (3).
4) Remove battery (4).
2
5. Body ground bolt
Remounting
1) Reverse removal procedure.
2) Tighten battery cables securely.
S7RS0B1A06002
4
1
5
3
I4RS0B1A0006-01
Water Pump / Generator Drive Belt Tension
Inspection and Adjustment
WARNING
!
Disconnect negative cable at battery before
checking and adjusting belt tension.
1) Inspect belt for cranks, cuts, deformation, wear and
clealiness. If it is necessary to replace belt, refer to
"Water Pump / Generator Drive Belt Removal and
Installation".
2) Check belt for tension. Belt is in proper tension when
it deflects the following specification under thumb
pressure (about 10 kg or 22 lb.).
If belt tension is out of specification, go to next steps.
Water pump / generator drive belt tension "a"
Existing belt: 4.5 – 5.5 mm (0.18 – 0.22 in.) as
deflection / 10 kg (22 lbs)
New belt: 3.5 – 4 mm (0.14 – 0.16 in.)as deflection
/ 10 kg (22 lbs)
Charging System: 1J-7
S7RS0B1A06003
"a"
I5JB0A1A0008-01