Malfunction Indicator Lamp (Mil) Check; Injection Warning Light (Gravity 1 Fault) Check; Red Stop Warning Light (Gravity 2 Fault) Check - Suzuki GRAND VITARA 2005 Service Manual

Information sensors

Malfunction Indicator Lamp (MIL) Check

Malfunction indicator lamp (1) signals an antipollution
system failure.
Check that it lights up for 3 seconds after the ignition
switch is turned ON, and then it goes OFF (automatic
test procedure).
If light remains ON after an automatic test procedure, go
to "DTC Check: ".
After the ignition switch is turned ON, if light does not
light up or remains ON, check that malfunction indicator
lamp circuit.
1
t: Inlet throttle valve
u: EGR valve
v: Boost pressure control solenoid valve
w: Additional heater relay No.1
x: Additional heater relay No.2
y: Additional heater relay No.3
Diagnostic Information and Procedures
S5JB0B1104001
I5JB0B110011-02
Engine General Information and Diagnosis:
Control devices

Injection Warning Light (Gravity 1 Fault) Check

Injection warning light (1) serves to indicate proper
functioning and to signal system failures.
After the ignition switch is turned ON, if lights remains
ON, go to "DTC Check: ".
If injection warning light flashes ON and OFF, there is
some trouble in the immobilizer control system referring
to "On-Board Diagnostic System Description (Self-
diagnosis Function): in Section 10C".
1

Red Stop Warning Light (Gravity 2 Fault) Check

Red stop warning light (1) serves to indicate proper
functioning and to signal system failures.
After the ignition switch is turned ON. if light remains ON,
go to "DTC Check: ".
1A-13
Others
S5JB0B1104002
I5JB0B110012-02
S5JB0B1104003
1
I5JB0B110013-02