Front Wheel Hub And Steering Knuckle Components; Front Wheel Hub, Steering Knuckle And Wheel Bearing Removal And Installation - Suzuki Swift Sport 2004 Service & Repair Manual

Front Wheel Hub and Steering Knuckle Components

1. Front wheel hub
2. Circlip
Front Wheel Hub, Steering Knuckle and Wheel
Bearing Removal and Installation
CAUTION
!
When removing and installing steering
knuckle assembly, be careful not to damage
dust boots of suspension control arm joint
by drive shaft dust cover and brake dust
cover.
Removal
1) Hoist vehicle and remove wheel.
2) Uncaulk drive shaft nut.
3) Depress foot brake pedal and hold it. Remove drive
shaft nut.
4) Remove brake disc referring to "Front Brake Disc
Removal and Installation in Section 4B".
5) Pull out wheel hub (1) with special tools.
Special tool
(A): 09943-17912
(B): 09942-15511
CAUTION
!
When wheel hub is removed, replace wheel
bearing with new one.
3. Wheel bearing
: Face grooved rubber seal side to wheel hub.
4. Steering knuckle
S7RS0B2206007
5. Drive shaft nut
: Calk, after tightening.
6. Hub bolt
6) Remove cotter pin and tie-rod end nut, and then
disconnect tie-rod end from steering knuckle
referring to "Tie-Rod End Removal and Installation in
Section 6C".
7) Remove wheel speed sensor (1) from steering
knuckle.
Front Suspension: 2B-8
S7RS0B2206006
I7RS0B220005-03
: 200 N⋅m (20.0 kgf-m, 145 lb-ft)
: Do not reuse.
I3RM0A220023-01
1
I4RS0B220005-01