Suzuki Swift Sport 2004 Service & Repair Manual page 487

7) Fasten boot bands (1) securely using special tool as
shown in figure.
Distance "a"
: 2.6 ± 1.4 mm (0.102 ± 55 in.)
CAUTION
!
Do not squeeze or distort boot when
fastening it with bands.
Distorted boot caused by squeezing air may
reduce its durability.
Special tool
(A): 09943–57010
1
"a"
(A)
1
(A)
1
I5RS0B310008-01
8) Set new differential side (or center shaft side) small
band and new differential side (or center shaft side)
boot (1) on shaft temporarily, and then apply grease
to tripod joint (2). Use specified grease in tube
included in spare parts.
9) Install tripod joint spider (3) on shaft using special
tool with hammer, directing its chamfered spline
toward wheel side, and then fasten it with new snap
ring (4) using snap ring pliers (5).
Special tool
(A): 09925–98221
10) Apply grease (including in spare parts) to inside of
tripod joint housing (1), joint it with tripod joint.
Grease color
"A": Dark gray
Amount
"A": 70 – 90 g (2.5 – 3.2 oz)
Drive Shaft / Axle: 3A-9
I5JB0A311009-01
I4RS0B310003-01