Table of Contents
Advertisement
2B-19 Front Suspension:
13) Install suspension control arm referring to
"Suspension Control Arm / Bushing Removal and
Installation".
14) Connect couplers of torque sensor and P/S motor.
15) Connect tie-rod ends to knuckles (right & left) and
then install cotter pins referring to "Tie-Rod End
Removal and Installation in Section 6C".
16) Be sure that steering wheel and brake discs (right &
left) are all straight-ahead position and then insert
steering lower shaft (5) into steering pinion shaft (3)
with matching marks (4).
17) Tighten steering shaft joint lower bolt (1) and upper
bolt (2) to specified torque (Lower side first and then
upper side).
Tightening torque
Steering shaft joint bolt (a): 25 N·m (2.5 kgf-m,
18.5 lb-ft)
5
1, (a)
4
3
18) Install both wheels and tighten wheel bolts to
specified torque.
Tightening torque
Wheel bolt: 85 N·m (8.5 kgf-m, 61.5 lb-ft)
19) Lower hoist.
20) Check toe setting. Adjust as required refer to "Front
Wheel Alignment Inspection and Adjustment".
Front Suspension Frame Check
Inspect for cracks, deformation or damage.
If defective, replace.
Front Stabilizer Bar, Bushing and/or Joint
Check
Stabilizer Bar
Inspect for damage or deformation.
If defective, replace.
Stabilizer Bushing
Inspect for damage, wear or deterioration.
If defective, replace.
2, (a)
5
1, (a)
I4RS0B630016-01
Stabilizer Joint
1) Check for smooth rotation.
2) Check damages of ball stud.
3) Check damages of dust cover.
NOTE
Stabilizer joint (1) cannot be disassembled.
If there is any damage to either parts, stabilizer joint
assembly must be replaced as a complete unit.
S7RS0B2206016
Front Suspension Fasteners Check
Check each bolt and nut fastening suspension parts for
I4RS0A220054-01
tightness. Tighten loose one, if any, to specified torque,
referring to "Front Suspension Construction".
S7RS0B2206017
I4RS0A220052-01
I4RS0A220056-01
1
I4RH01220007-01
S7RS0B2206018
Hide quick links:
Advertisement
Chapters
Table of Contents
