Suzuki Swift Sport 2004 Service & Repair Manual page 450

2B-17 Front Suspension:
15) Remove stabilizer bar (1) and bushing from front
suspension frame (2).
2
Installation
1) When installing stabilizer, loosely assemble all
components while insuring that stabilizer is centered,
side-to-side.
2) Install stabilizer bar (1), stabilizer bushing (2) and
stabilizer mounting bracket (3) to front suspension
frame as shown in figure.
NOTE
For correct installation of stabilizer bar, side-
to-side, be sure that stopper ring (4) on
stabilizer bar aligns with mount bush, both
right and left, as shown in figure.
3) Tighten stabilizer bar mounting bracket bolts to
specified torque.
Tightening torque
Stabilizer bar mounting bracket bolt (a): 23 N·m (
2.3 kgf-m, 17.0 lb-ft)
F: Forward
1
I4RS0A220044-01
I4RS0A220055-01
4) Mount steering gear case (1) to front suspension
frame (2) and tighten gear case mounting No.1 bolts
(3) and No.2 bolts (4) to specified torque.
Tightening torque
Steering gear case mounting No.1 bolt (a): 55
N·m (5.5 kgf-m, 40.0 lb-ft)
Steering gear case mounting No.2 bolt (b): 55
N·m (5.5 kgf-m, 40.0 lb-ft)
3, (a)
5) Support front suspension frame (2) with stabilizer bar
by using mission jack (1), and jack up it.
6) Align lugs (1) (right and left) of front suspension
frame with holes (2) in vehicle body respectively.
4, (b)
1
2
I4RS0B220011-02
2
1
I4RS0A220046-01
2
1
I4RS0A220047-01