Manual Transaxle Unit Dismounting And Remounting - Suzuki Swift Sport 2004 Service & Repair Manual

Manual Transaxle Unit Dismounting and
Remounting
Dismounting
1) Drain coolant and transaxle oil.
2) Remove coolant reservoir with reservoir hose.
3) Remove battery and tray.
4) Remove air cleaner case and resonator.
5) Disconnect gear shift and gear select control cables
(1) while pressing claws (2) of clip (3).
3
6) Disconnect back up light switch coupler and undo
wiring harness clamps.
7) Remove ground cable from transaxle.
8) Remove clutch operating cylinder with fluid hose
from transaxle.
9) Remove water inlet No.2 pipe from transaxle.
10) Remove starting motor referring to "Starting Motor
Dismounting and Remounting in Section 1I".
11) Remove transaxle to engine bolts (1) of upper side.
1
S7RS0B5206009
2
1
I7RS0A521003-01
1
I4RS0A520018-01
Manual Transmission/Transaxle:
12) Support engine using supporting device (1).
CAUTION
!
Do not apply supporting device to projection
part A. If do so, it may be deformed.
13) Remove front drive shafts and center shaft referring
to "Front Drive Shaft Assembly Removal and
Installation in Section 3A".
14) Remove exhaust No.2 pipe referring to "Exhaust
Pipe and Muffler Removal and Installation in Section
1K".
15) Remove clutch housing lower plate (1).
5B-9
1
A
I4RS0A520019-01
1
I4RS0A520020-01