9D-9 Wipers / Washers:
Washer Linked Circuit
1) Make sure that front wiper switch is at "OFF"
position.
2) Connect battery positive (+) terminal to terminal "5"
and its negative (–) terminal to terminal "2".
3) Connect voltmeter positive lead to terminal "4" and
its negative lead to terminal "2".
4) When front washer switch is ON, check that voltage
changes as shown in figure.
If check result is not satisfied, replace switch.
ON
OFF
High
Low
Approx. 0.3 sec.
[L]
5
4
[R]: RH steering vehicle
Approx. 2.2 sec.
2
2
[R]
4
5
V
I5RS0C940004-01
[L]: LH steering vehicle
Rear Wiper and Washer Switch Removal and
Installation
For removal and installation, refer to "Windshield Wiper
and Washer Switch Removal and Installation".
Rear Wiper and Washer Switch Inspection
Check for continuity between terminals at each switch
position. If check result is not as specified, replace
switch.
[R]
3
2
1
4
Terminal
Position
OFF
INT
ON
ON + WASH
WASH
[R]: RH steering vehicle
[L]: LH steering vehicle
S7RS0B9406010
S7RS0B9406011
ON + WASH
ON
INT
WASH
[L]
1 2 3
4
1
2
3
4
I5RS0C940005-01