Suzuki Swift Sport 2004 Service & Repair Manual page 1140

8B-102 Air Bag System:
4) Remove air bag (inflator) module from steering
wheel.
5) Disconnect driver air bag (inflator) module connector
(1) of driver air bag (inflator) module and horn
connector (2) as shown in figure.
a) Unlock lock button (3).
b) With lock button unlocked, disconnect connector.
1
WARNING
!
Special care is necessary when handling and
storing a live (undeployed) air bag (inflator)
module. Observe "Precautions on Handling
and Storage of Air Bag System
Components". Otherwise, personal injury
may result.
a)
3
b)
2
I4RS0A820057-01
Installation
1) Connect horn connector (1) securely.
2) Connect driver air bag (inflator) module connector
(2) to driver air bag (inflator) module (3) securely as
shown in figure.
a) Connect connector.
b) Lock connector with lock button.
1
3) Install driver air bag (inflator) module (1) to steering
wheel (2), taking care so that no part of wire harness
is caught between them.
4) Make sure that clearance between module (1) and
steering wheel (2) is uniform all the way.
5) Tighten driver air bag (inflator) module mounting bolt
(left side) (3) to specified torque first and then driver
air bag (inflator) module mounting bolt (right side) (4)
to specified torque.
Tightening torque
Driver air bag (inflator) module mounting bolt
(a): 9 N·m (0.9 kgf-m, 6.5 lb-ft)
6) Enable air bag system. Refer to "Enabling Air Bag
System".
7) Connect negative cable at battery.
b)
3
a)
2
I4RS0A820058-01
I5RH01820103-01