Suzuki Swift Sport 2004 Service & Repair Manual page 438

2B-5 Front Suspension:
5) Remove brake hose mounting bolt (1) and remove
brake hose (2) from bracket and then wheel speed
sensor harness (3) from strut bracket as shown in
figure.
6) Remove strut bracket bolts and nuts (4).
1
2
4
3
7) Remove strut rod cap.
8) Remove strut nut (1), and remove rebound stopper
(2).
NOTE
Hold strut by hand so that it will not fall off.
9) Remove strut assembly.
Installation
Install strut assembly by reversing removal procedure,
noting the following instructions.
CAUTION
!
Never reuse strut bracket nuts.
Nuts are pre-coated with friction stabilizer.
Be sure to replace pre-coated nut with a new
one, or nut may loosen.
• Insert bolts in such direction as shown in figure.
• Tighten all fasteners to specified torque.
3
2
1
4
I4RS0A220005-01
2
1
I4RS0A220006-01
Tightening torque
Strut bracket nut (a): 90 N·m (9.0 kgf-m, 65.5 lb-ft)
Brake hose mounting bolt (c): 25 N·m (2.5 kgf-m,
18.0 lb-ft)
Stabilizer joint nut (d): 50 N·m (5.0 kgf-m, 36.5 lb-
ft)
• Lower hoist and vehicle in unloaded condition, tighten
strut nut (b) to specified torque.
Tightening torque
Strut nut (b): 50 N·m (5.0 kgf-m, 36.5 lb-ft)
• Install windshield wiper arms with blades referring to
"Windshield Wiper Removal and Installation in
Section 9D".
NOTE
• Don't twist brake hose and wheel speed
sensor harness when installing them.
• Install wheel speed sensor harness (1)
which marking (2) in figure is placed to
open hook side of the bracket.
(b)
(c)
(d)
1
2
(a)
I4RS0B220012-01