Repair Instructions - Suzuki Swift Sport 2004 Service & Repair Manual

General Balance Procedures
Deposits of mud, etc. must be cleaned from inside of rim.
WARNING
!
Stones should be removed from the tread in
order to avoid operator injury during spin
balancing and to obtain good balance.
Each tire should be inspected for any damage, then
balanced according to equipment manufacturer's
recommendation.
Off-Vehicle Balancing
Most electronic off-vehicle balancers are more accurate
than the on-vehicle spin balancers. They are easy to use
and give a dynamic (two plane) balance. Although they
do not correct for drum or disc unbalance as does on-
vehicle spin balancing, this is overcome by their
accuracy, usually to within 1/8 ounce.
On-Vehicle Balancing
On-vehicle balancing methods vary with equipment and
tool manufacturers. Be sure to follow each
manufacturer's instructions during balancing operation.
WARNING
!
Wheel spin should be limited to 55 km/h (35
mph) as indicated on speedometer.
This limit is necessary because speedometer
only indicates one-half of actual wheel speed
when one drive wheel is spinning and the
other drive wheel is stopped.
Unless care is taken in limiting drive wheel
spin, spinning wheel can reach excessive
speeds. This can result in possible tire
disintegration or differential failure, which
could cause serious personal injury or
extensive vehicle damage.
CAUTION
!
Using on-vehicle balancing method with
ignition switch ON may set malfunction
diagnostic trouble code (DTC) of ESP® and
ABS even when system is in good condition.
Never turn ignition switch ON while spinning
wheel.

Repair Instructions

Tire Rotation
S7RS0B2406001
To equalize wear, rotate tires according to figure. Radial
tires should be rotated periodically. Set tire pressure.
Wheels and Tires:
[A]: Rotation direction is not indicated.
[B]: Rotation direction is indicated.
2D-6
S7RS0B2406002
I6RS0C240002-01