Dtc B1085 / B1095: Wrong Side-Sensor - Suzuki Swift Sport 2004 Service & Repair Manual

Step
2 1) Disconnect service wire from "L11" or "L35" connector.
2) Measure voltage between "L29-46" terminal and body
ground, "L29-47" terminal and body ground or "L29-44"
terminal and body ground, "L29-45" terminal and body
ground.
With ignition switch ON, is each measured value 1 V or less?
3 1) Check side-sensor referring to "Side-Sensor Inspection".
Is it in good condition?
NOTE
Upon completion of inspection and repair work, perform the following items.
• Reconnect all air bag system components and ensure all components are properly mounted.
• Clear DTCs referring to "DTC Clearance", if any.
• Repeat "Air Bag Diagnostic System Check" to confirm that the trouble has been corrected.
DTC B1085 / B1095: Wrong Side-Sensor (Driver Side / Passenger) ID
DTC Will Set when
SDM receives wrong ID (Part No.) signal from side-sensor.
DTC Troubleshooting
1) Turn ignition switch OFF.
2) Replace driver or passenger side-sensor referring to "Side-Sensor Removal and Installation".
3) Repeat "Air Bag Diagnostic System Check".
NOTE
Upon completion of inspection and repair work, perform the following items.
• Reconnect all air bag system components and ensure all components are properly mounted.
• Clear DTCs referring to "DTC Clearance", if any.
• Repeat "Air Bag Diagnostic System Check" to confirm that the trouble has been corrected.
Action
"L29-44" "L29-45""L29-46""L29-47"
(A)
Yes
Go to Step 3.
I7RS0A820030-01
Substitute a known-
good SDM and recheck.
Air Bag System: 8B-83
No
DTC B1084: "WHT/
RED" circuit or "LT
GRN/BLK" circuit
shorted to power supply
circuit.
DTC B1094: "WHT/
GRN" circuit or "LT
GRN" circuit shorted to
power supply circuit.
Replace side-sensor
referring to "Side-
Sensor Removal and
Installation". If DTC still
exists, substitute a
known-good SDM and
recheck.
S7RS0B8204042