Dtc Table - Suzuki Swift Sport 2004 Service & Repair Manual

DTC Table

NOTE
• A: Driving cycles when transmission warning light lighting and storing DTC in TCM memory.
• *1: Transmission warning light does not light up but TCM detects and stores DTC.
• For details of driving cycle, refer to "On-Board Diagnostic System Description".
DTC No. Detecting item
P0602 Control module programming error
Transmission range sensor circuit
P0705
malfunction (PRNDL input)
Transmission range sensor circuit
P0707
low
Transmission fluid temperature
P0712
sensor "A" circuit low
Transmission fluid temperature
P0713
sensor "A" circuit high
Input / Turbine speed sensor circuit
P0717
no signal
P0722 Output speed sensor circuit no signal
P0787 Shift / Timing solenoid low
P0788 Shift / Timing solenoid high
Pressure control solenoid "A" control
P0961
circuit range / performance
Pressure control solenoid "A" control
P0962
circuit low
Pressure control solenoid "A" control
P0963
circuit high
P0973 Shift solenoid "A" control circuit low
P0974 Shift solenoid "A" control circuit high
P0976 Shift solenoid "B" control circuit low
P0977 Shift solenoid "B" control circuit high
Internal control module memory
P1702
check sum error
P1703 CAN invalid data - TCM
P1723 Range select switch malfunction
Control module communication bus
P1774
off
Automatic Transmission/Transaxle:
Detecting condition
(DTC will set when detecting)
Data programming error.
Multiple signals are inputted simultaneously.
No sensor signal is inputted.
Sensor output voltage is too low.
Sensor output voltage is too high.
No sensor signal is detected although output
speed sensor signal is inputted.
No sensor signal is inputted although input
speed sensor signal is inputted.
Voltage of timing solenoid terminal is low
although TCM is commanding timing solenoid
to turn ON.
Voltage of timing solenoid terminal is high
although TCM is commanding timing solenoid
to turn OFF.
Difference between target current of control
solenoid valve circuit and monitor current of
control solenoid valve circuit is more than
specification.
No electric flow is detected on pressure control
solenoid circuit.
Too much electric flow is detected on pressure
control solenoid circuit.
Voltage of shift solenoid terminal is low
although TCM is commanding shift solenoid to
turn ON.
Voltage of shift solenoid terminal is high
although TCM is commanding shift solenoid to
turn OFF.
Voltage of shift solenoid terminal is low
although TCM is commanding shift solenoid to
turn ON.
Voltage of shift solenoid terminal is high
although TCM is commanding shift solenoid to
turn OFF.
Calculation of current data stored in TCM is not
correct comparing with pre-stored checking
data in TCM.
TCM receives malfunction signal of throttle
position, engine coolant temperature, engine
revolution and engine torque from ECM.
"3" position switch ON signal is inputted
although transmission range switch signal is
inputted P, R, N or L. range.
Transmitting and receiving error detected to
TCM for specified time continuously.
5A-19
S7RS0B5104005
A
*1, 1 driving cycle
1 driving cycle
2 driving cycles
1 driving cycle
1 driving cycle
1 driving cycle
1 driving cycle
1 driving cycle
1 driving cycle
1 driving cycle
1 driving cycle
1 driving cycle
1 driving cycle
1 driving cycle
1 driving cycle
1 driving cycle
1 driving cycle
*1, 1 driving cycle
*1, 1 driving cycle
1 driving cycle