Rear Wheel Disc, Bolt And Bearing Inspection - Suzuki Swift Sport 2004 Service & Repair Manual

Installation
Install wheel hub by reversing removal procedure noting
the following instructions.
• Insert new wheel stud bolt in wheel hub hole and
rotate it slowly to assure serrations are aligned with
those made by replaced bolt.
• Never apply grease to encoder (1).
• Install new rear axle nut (1) and tighten to specified
torque.
CAUTION
!
Never reuse rear axle nut. Otherwise, nut may
loosen.
Tightening torque
Rear axle nut (a): 175 N·m (17.5 kgf-m, 126.5 lb-ft)
• Caulk new rear axle nut (1) as shown.
Take care while staking nut. If a split occurs
in staked area of nut, replace it with new one.
Stake specification
"a": 0.5 mm (0.02 in.) or more
I6RS0C230004-01
1
• Install new spindle cap.

Rear Wheel Disc, bolt and Bearing Inspection

• Check tightness of wheel nuts and, if necessary,
retighten to specified torque.
• Check wheel disc deformation, damage, crack and
I6RS0B230012-01
etc.
Replace defective disc with new one.
• Check installation face inside of wheel disc for rust.
As rust affects adversely, remove it thoroughly.
Tightening torque
Wheel nut: 85 N·m (8.5 kgf-m, 61.5 lb-ft)
• Check wear of wheel bearings. When measuring
thrust play, apply a dial gauge to axle shaft center.
When the thrust play exceeds limit, replace bearing.
Rear wheel bearing thrust play limit
"a": 0.1 mm (0.004 in.)
1, (a)
I6RS0B230013-01
Rear Suspension:
CAUTION
!
2C-11
1
"a"
I6RS0B230014-01
S7RS0B2306013
I7RS0A230002-02