Suzuki Swift Sport 2004 Service & Repair Manual page 831

5) Remove gear shift locating bolts (1) with washers,
then take out locating springs and steel balls.
6) Remove back up light switch (2).
7) Remove reverse shaft bolt (2) with washer.
8) Remove case bolts (1) from outside and another
bolts from clutch housing side.
9) Tapping left case flanges with plastic hammer,
remove left case (3).
10) Pull out reverse gear shaft (1) with washer (2), then
take off reverse idler gear (3).
11) Remove reverse gear shift lever bolts (4) and
reverse gear shift lever (5).
12) Pull out 5th & reverse gear shift guide shaft (6)
together with 5th & reverse gear shift shaft (7).
13) Tapping input shaft end with plastic hammer, push it
out as assembly from case a little, then take out
input shaft assembly (1), countershaft assembly (2),
high speed gear shift shaft (3) and low speed gear
shift shaft (4) all at once.
I2RH01520032-01
14) Remove countershaft left bearing outer race from left
case (1) using special tool.
Special tool
(A): 09913–70123
I4RS0A520032-01
15) Remove side bearing retainer bolts.
16) Turn side bearing retainer (1) counterclockwise until
it stops, and remove side bearing retainer using 2 flat
end rods (2) or the like.
17) Remove O-ring from side bearing retainer.
2
I4RS0A520033-01
Manual Transmission/Transaxle:
1
5B-17
I2RH01520035-01
(A)
I4RH01520021-01
1
2
I4RS0A520034-01