Suzuki Swift Sport 2004 Service & Repair Manual page 1373

Installation
Reverse removal procedure to install door assembly
noting the following instructions.
• When replacing door, coat replacement door inside
with wax for proper anti-corrosion treatment. Refer to
"Sealant Application Areas in Section 9L".
• Apply sealant to contact face "A" of hinge (1) and
apply grease to rotating part "B" of hinge (1).
Specified sealant and grease.
"A": Sealant 99000–31110 (SUZUKI Bond
No.1215)
"B": Grease 99000–25010 (SUZUKI Super Grease
A)
• Tighten hinge bolt to specified torque.
Tightening torque
Door hinge mounting bolt (body side) (a): 27 N·m
(2.7 kgf-m, 19.5 lb-ft)
Door hinge mounting bolt (door side) (b): 23 N·m
(2.3 kgf-m, 17.0 lb-ft)
• When door open stopper (1) is installed, be careful
make sure punch mark (2) comes to the top.
Door open stopper installing direction
Left side door: L punch mark is upward
Right side door: R punch mark is upward
• Tighten door open stopper bolt (3) to specified torque.
Tightening torque
Door open stopper bolt (a): 21 N·m (2.1 kgf-m,
15.5 lb-ft)
• Adjust door latch striker position referring to "Front
Door Lock Assembly Removal and Installation in
Section 9F".
• Adjust front door cushion so that door becomes flush
with side body.
• After installation, open and close the door to check
looseness.
I4RS0A9A0007-01
Hood / Fenders / Doors:
I4RS0A9A0008-01
9J-4