Front Wheel Speed Sensor Inspection; Rear Wheel Speed Sensor Removal And Installation - Suzuki Swift Sport 2004 Service & Repair Manual

Installation
CAUTION
!
Do not pull or twist wire harness more than
necessary when installing front wheel speed
sensor.
1) Check that no foreign material is attached to
sensor(1) and mating encoder (2).
2) Install it by reversing removal procedure.
Tightening torque
Front wheel speed sensor bolt (a): 11 N·m (1.1
kgf-m, 8.0 lb-ft)
Front wheel speed sensor harness clamp bolt
(b): 11 N·m (1.1 kgf-m, 8.0 lb-ft)
3) Check that there is no clearance between sensor
and knuckle.
(b)
1
2
[A]
1
[A]: OK
(a)
[B]
1
I6RS0B460033-02
[B]: NG
Electronic Stability Program:

Front Wheel Speed Sensor Inspection

Check sensor for damage.
If any malcondition is found, replace.
Rear Wheel Speed Sensor Removal and
Installation
CAUTION
!
• Do not pull wire harness when removing
rear wheel speed sensor.
• Do not cause damage to surface of rear
wheel speed sensor and do not allow dust,
etc. to enter its installation hole.
Removal
1) Disconnect negative (–) cable from battery.
2) Remove quarter inner trim to brake referring to
"Floor Carpet Removal and Installation in Section
9H".
3) Turn over floor carpet (2) and disconnect connector
(1) of wheel speed sensor.
1
2
4F-59
S7RS0B4606030
I5JB0A450031-01
S7RS0B4606031
2
I6RS0B460035-02