Assembly
1) Front bushing
Press-fit front bushing (1) by using special tools and
press (2).
Special tool
(A): 09943–76310
(B): 09913–75821
CAUTION
!
Be sure to use new bushing.
NOTE
• Before installing bushing, apply soap
water on its circumference to facilitate
bushing installation.
2) Press-fit bushing (1) so that dimensions "A" and "B"
in figure become equal.
Suspension Control Arm / Steering Knuckle
Check
Inspect for cracks, deformation or damage.
If defective, replace.
Suspension Control Arm Bushing Check
Inspect for damage, wear or deterioration.
If defective, replace.
2
Suspension Control Arm Joint Check
(B)
• Check smooth rotation of ball stud.
1
• Check damages of ball stud.
• Check damages of dust cover.
(A)
I6RS0C220014-01
If there is any damage to either parts, control arm
assembly must be replaced as a complete unit.
I4RS0A220033-01
Front Suspension:
NOTE
Suspension control arm and arm joint cannot
be separated.
2B-14
S7RS0B2206011
S7RS0B2206012
I6RS0C220015-01
S7RS0B2206013
I4RS0B220023-01