Headlight Bulb Replacement; Headlight Aiming Adjustment With Screen - Suzuki Swift Sport 2004 Service & Repair Manual

9B-6 Lighting Systems:

Headlight Bulb Replacement

WARNING
!
• To avoid danger of being burned, don't
touch when the bulb is hot.
• Don't touch glass surface of bulb, to avoid
deteriorate as the case may be unclear
when bulb light on at dirty condition.
1) Disconnect negative (–) cable at battery.
2) Disconnect coupler from bulb.
3) Remove socket cover (1).
4) Replace bulb (2) and assemble all removed parts.
2
S7RS0B9206002
1
iii)
i)
ii)
I4RS0A920005-01

Headlight Aiming Adjustment with Screen

NOTE
• Unless otherwise obligated by local
regulations, adjust headlight aiming
according to the following procedure.
• After replacing headlight housing, be sure
to adjust aiming.
• When inspecting and adjusting headlight
with leveling system, make sure to set the
leveling switch to "0" position with ignition
switch turned ON.
1) Make sure the following items.
• Place vehicle on a flat surface in front of blank wall
(screen) (1) ahead of headlight surface.
Distance "a"
10 m (32.8 ft.)
• Adjust air pressure of all tires to the specified
value respectively.
• Bounce vehicle body up and down by hand to
stabilize suspension.
• Carry out aiming with a driver aboard.
Driver's weight
75 kg (165 lb)
2) Check to see if hot spot (high intensity zone) of each
low beam axis falls as shown in figure.
NOTE
If the headlights interfere each other and
make it hard to see the cut line clearly, cover
the headlight on one side. This helps to make
aiming adjustment easier.
Hot spot specification
Angle "b": 0.75° (Specification)
Calculated distance "H": Approx. 130 mm (5.15
in.)
S7RS0B9206003