Suzuki Swift Sport 2004 Service & Repair Manual page 1071

Step
4 1) With ignition switch OFF, disconnect special tools (B)
and (C) from "G26" connector and reconnect contact coil
connector located under of the steering column.
2) Remove driver air bag (inflator) module from steering
column referring to "Driver Air Bag (Inflator) Module
Removal and Installation".
3) Check proper connection to driver air bag (inflator)
module connector.
4) If OK, then connect special tools (A), (B) and (E) to
driver air bag (inflator) module connector.
Special tool
(A): 09932-76010
(B): 09932-75010
(C): 09932–78340
(E): 09932-78310
STEERING WHEEL
5) Check SDM DTC.
With ignition switch ON, is DTC B1032 indicated?
NOTE
Upon completion of inspection and repair work, perform the following items.
• Reconnect all air bag system components and ensure all components are properly mounted.
• Clear DTCs referring to "DTC Clearance", if any.
• Repeat "Air Bag Diagnostic System Check" to confirm that the trouble has been corrected.
Action
(A)
(E)
(B)
I4RS0A820017-01
Air Bag System:
Yes
Turn ignition switch
OFF. Replace contact
coil assembly referring
to "Contact Coil Cable
Assembly Removal and
Installation in Section
6B".
8B-33
No
Turn ignition switch
OFF. Replace driver air
bag (inflator) module
referring to "Driver Air
Bag (Inflator) Module
Removal and
Installation".