Suzuki Swift Sport 2004 Service & Repair Manual page 807

70) After applying A/T fluid to new governor apply No.1
gasket (1), install it to transaxle case.
71) After applying A/T fluid to new O-ring, fit it to valve
body harness connector (3), then install valve body
harness to transaxle case.
CAUTION
!
When put valve body harness (1) into
transaxle case, take care not to damage
transmission fluid temperature sensor (2) at
narrow entrance of case.
Careless sensor treatment might cause
sensor malfunction.
Tightening torque
Valve body harness connector bolt (a): 5.5 N·m (
0.55 kgf-m, 4.0 lb-ft)
Automatic Transmission/Transaxle:
72) Install manual valve rod (1) to manual valve lever (3)
and then install valve body assembly (2) to transaxle
case.
I2RH0B510320-01
73) Tighten valve body bolts to specified torque.
Tightening torque
Valve body bolt: 11 N·m (1.1 kgf-m, 8.0 lb-ft)
Valve body bolt length
Bolt
A (1)
B (2)
C (3)
D (4)
E (5)
I2RH0B510321-01
Length "a"
20 mm (0.79 in.)
28 mm (1.10 in.)
49 mm (1.93 in.)
36 mm (1.42 in.)
40 mm (1.58 in.)
5A-163
I2RH0B510322-01
Pieces
6
5
1
1
1
I2RH0B510323-01