Suzuki Swift Sport 2004 Service & Repair Manual page 751

Remounting
1) Make sure that torque converter is installed correctly
to transaxle.
Refer to "Automatic Transaxle Unit Assembly".
2) Attach transaxle to engine.
WARNING
!
Be sure to keep transaxle with torque
converter horizontal or facing up throughout
the work. Should it be tilted with torque
converter down, converter may fall off and
cause personal injury.
Tightening torque
Transaxle and engine fastening bolt and nut
(a): 85 N·m (8.5 kgf-m, 61.5 lb-ft)
3) Tighten drive plate to torque converter bolts. Align
bolt hole of drive plate and torque converter then
tighten bolts through torque converter housing lower
plate opening.
Lock drive plate (1) by engaging flat head rod or the
like (2) with drive plate gear.
Tightening torque
Drive plate to torque converter bolt (a): 25 N·m (
2.5 kgf-m, 18.0 lb-ft)
3. Wrench
I3RM0B510050-01
I3RM0B510051-01
4. Engine oil pan
Automatic Transmission/Transaxle:
4) Tighten transaxle stiffener bolts to specified torque.
5) Install transaxle housing lower plates (1).
Tightening torque
Transaxle stiffener bolt (a): 55 N·m (5.5 kgf-m,
40 lb-ft)
(a)
6) Install starter motor.
Tightening torque
Starter motor bolt and nut: 50 N·m (5.0 kgf-m,
36.5 lb-ft)
7) Remount engine with transaxle assembly to vehicle.
Refer to "Engine Assembly Removal and Installation
in Section 1D" for its procedure.
5A-107
1
I4RS0A510056-01