Forward-Sensor Inspection; Side-Sensor Removal And Installation - Suzuki Swift Sport 2004 Service & Repair Manual

8B-110 Air Bag System:
Installation
CAUTION
!
Proper operation of forward-sensor requires
sensor be rigidly attached to vehicle
structure and that the arrow on sensor be
pointing toward the front of the vehicle.
1) Check that none of the following faulty conditions
exists.
• Bend, deformity or rust of front panel.
• Foreign matter on mating surface of sensor.
2) Apply thread lock cement to mounting bolts thread.
Install forward-sensor (1) on front panel and tighten
mounting bolt (2) to specified torque.
"A": Thread lock cement 99000–32100 (Thread
Lock Cement 1305)
Tightening torque
Forward-sensor mounting bolt (a): 9 N·m (0.9
kgf-m, 6.5 lb-ft)
3) Connect forward-sensor connector by pushing
connector till click is heard from it.
4) Connect negative cable at battery.
5) Enable air bag system referring to "Enabling Air Bag
System".

Forward-Sensor Inspection

WARNING
!
During service procedures, be very careful
when handling a sensor.
• Never strike or jar a sensor.
• A sensor and mounting bracket bolts must
be carefully torqued to assure proper
operation. Under loose connection, it
could cause improper operation of the air
bag system.
CAUTION
!
• Never disassemble forward-sensor.
• Sensor should be replaced when it was
dropped from a height of 90 cm (3 ft) or
more.
2,"A",(a)
1
I5RH01820120-01
S7RS0B8206014
• Check sensor for dents, cracks or deformation.
• Check sensor connector (sensor side and harness
side) and sensor connector lock mechanism for
damage or crack.
• Check connector terminals for bend, corrosion or rust.

Side-Sensor Removal and Installation

WARNING
!
During service procedures, be very careful
when handling a sensor.
• Never strike or jar a sensor.
• A sensor bolt must be carefully torqued to
assure proper operation. Under loose
connection, it could cause improper
operation of the air bag system.
Removal
1) Disconnect negative (–) cable at battery.
2) Disable air bag system. Refer to "Disabling Air Bag
System".
3) Remove center pillar lower trim and side sill scuff.
4) Turn up floor carpet at front seat side.
5) Remove side-sensor bolt (1), and side-sensor (2)
from under body (3).
S7RS0B8206015
3
2
1
I4RS0A820080-01