Suzuki Swift Sport 2004 Service & Repair Manual page 824

5B-10 Manual Transmission/Transaxle:
16) Remove engine under covers.
17) Support transaxle with transmission jack.
18) Remove transaxle to engine bolts and nut of lower
side.
19) Remove engine left mounting (1) with bracket (2).
20) Remove engine rear mounting bracket bolts (1).
21) Remove other attached parts from transaxle, if any.
22) Pull transaxle so as to disconnect input shaft from
clutch disc, and then lower it.
1
2
I4RS0A520021-01
1
I4RS0A520022-01
Remounting
CAUTION
!
• Care should be taken not to scratch oil
seal lip with drive shaft while raising
transaxle.
• Do not hit drive shaft joint with hammer
when installing it into differential gear.
Reverse dismounting procedure for remounting noting
the following.
• Tighten each bolts and nuts to specified torque
referring to "Manual Transaxle Unit Components".
• Set each clamp for wiring securely.
• Fill transaxle oil referring to "Manual Transaxle Oil
Change".
• Fill coolant referring to "Cooling System Flush and
Refill in Section 1F".
• Install hook (1) and ground cable (2) at specified
position as shown in figure.
1
2
4
3. Transaxle side cover
• Connect battery and check function of engine, clutch
and transaxle.
3
I4RS0A520023-01
4. Transaxle left case