Suzuki Swift Sport 2004 Service & Repair Manual page 1144

8B-106 Air Bag System:
4) Remove side-air bag (inflator) module from seat
back.
5) Disconnect side-air bag (inflator) module connector
(1) as shown in figure.
a) Unlock lock button (2).
b) With lock button unlocked, disconnect connector.
1
WARNING
!
• When carrying a live air bag (inflator)
module, make sure the bag opening is
pointed away from you.
Never carry air bag (inflator) module by
wires or connector on the side of the
module. In case of an accidental
deployment, the bag will then deploy with
minimal chance of injury.
• As the live side-air bag (inflator) module
must be kept with its bag (trim cover)
facing up while being stored or left
standing. This is necessary so that a free
space is provided to allow the air bag to
expand in the unlikely event of accidental
deployment.
• Observe "Precautions on Handling and
Storage of Air Bag System Components"
for handling and storing it.
Otherwise, personal injury may result.
CAUTION
!
Do not damage the sleeve. Otherwise, the
side-air bag cannot be correctly installed to
seat back.
a)
2
b)
I4RS0A820068-01
Installation
1) Confirm sleeve (1) is surely installed in side-air bag
(inflator) module.
2) Tighten sleeve lock nut (2) to specified torque.
Tightening torque
Sleeve lock nut (a): 2.5 N·m (0.25 kgf-m, 2.0 lb-ft)
3) Install new clip to seat back.
2, (a)
4) Connect side-air bag (inflator) module connector (1)
securely as shown in figure.
a) Connect connector.
b) Lock connector with lock button (2).
1
5) Insert claw (1) of side-air bag (inflator) module on
installation hole (2).
6) Push side-air bag (inflator) module into clip (3) with
specified force.
Side-air bag (inflator) module installation force
Pushing force: 180 N
1
I4RS0A820073-02
b)
2
a)
I4RS0A820070-01
2
3
1
I4RS0A820074-02