Dtc B1041: Passenger Air Bag Initiator Circuit Resistance High - Suzuki Swift Sport 2004 Service & Repair Manual

8B-44 Air Bag System:

DTC B1041: Passenger Air Bag Initiator Circuit Resistance High

Wiring Diagram
1
2
[A]
[A]: Shorting bar
1. From main fuse
2. Ignition switch
CAUTION
!
• Be sure to perform "Air Bag Diagnostic System Check" before starting diagnosis according to flow.
• When measurement of resistance or voltage is required in this flow, use a tester along with a correct
terminal adaptor from special tool (Connector test adapter kit).
• When a check for proper connection is required, refer to "Inspection of Intermittent and Poor
Connections".
• If there is open circuit in the air bag wire harness, connector or terminal is found damaged, replace
the wire harness, connector and terminal as an assembly.
DTC Will Set when
The combined resistance of the passenger air bag (inflator) module, harness wiring and connector terminal contact is
above a specified value for specified time.
Flow Test Description
Step 1: Check if malfunction is in passenger air bag (inflator) module.
Step 2: Check passenger air bag (inflator) module initiator circuit. (in instrument panel harness)
Step 3: Check passenger air bag (inflator) module initiator circuit. (in floor harness)
"L04"
4
RED
GRN
"G32"
3
BLK
7
"L29"
3. "A/BAG" fuse
4. Junction block assembly
5. SDM
5
"L29"
L29-27 IG
BLU/RED
P+ L29-5
YEL/RED
P- L29-6
L29-28 E1
6. Passenger air bag (inflator) module
7. Ground for air bag system
"L32" "G04"
"G10"
BLU/RED
6
YEL/RED
S7RS0B8204022
I7RS0A820013-06