Washer Tank And Washer Pump Removal And Installation; Washer Pump Inspection - Suzuki Swift Sport 2004 Service & Repair Manual

9D-3 Wipers / Washers:
1. Windshield wiper blade
2. Windshield wiper arm
3. Windshield wiper motor
4. Windshield wiper link
5. Rear wiper arm with blade assembly
6. Rear wiper motor
7. Washer pump for windshield washer
Washer Tank and Washer Pump Removal and
Installation
Removal
1) Disconnect negative (–) cable at battery.
2) Remove front bumper referring to "Front Bumper
and Rear Bumper Components in Section 9K".
3) Remove grommet (1) and upper part (2) of washer
tank.
1
2
4) Remove washer tank attaching bolts (4).
5) Disconnect washer pump lead wire couplers and
hoses.
6) Remove washer tank (1).
7) Remove windshield washer pump (2) and rear
washer pump (3) from washer tank (1).
3
8. Washer pump for rear washer
9. Washer tank
10. Washer hose
11. Washer nozzle
12. Wiper switch
13. Rear wiper relay
14. Junction block assembly
S7RS0B9406002
I4RS0A940002-01
4
1
2
I4RS0A940003-01
: BCM cannot be removed from junction block.
Installation
Install washer tank and washer pump by reversing
removal procedure, noting the following instructions.
• Connect washer pump connector(s) securely.
• Tighten washer tank bolts to specified torque.
Tightening torque
Washer tank bolt (a): 4 N·m (0.4 kgf-m, 3.0 lb-ft)

Washer Pump Inspection

1) Connect battery positive (+) and negative (–)
terminals to pump (+) and (–) terminals respectively.
2) Check windshield and rear washer pumps for
operation.
If pump does not operate, replace washer pump.
[A]: Junction block assembly viewed
from relay side
: 16 N⋅m (1.6 kgf-m, 11.5 lb-ft)
: 8 N⋅m (0.8 kgf-m, 6.0 lb-ft)
: 5 N⋅m (0.5 kgf-m, 4.0 lb-ft)
: 4 N⋅m (0.4 kgf-m, 3.0 lb-ft)
(a)
I4RS0A940004-01
S7RS0B9406003
(–)
(+)
I4RS0A940005-01