Front Fog Light Removal And Installation (If Equipped); Front Fog Light Bulb Replacement (If Equipped); Front Fog Light Switch Inspection (If Equipped); Front Fog Light Relay Inspection (If Equipped) - Suzuki Swift Sport 2004 Service & Repair Manual

Front Fog Light Removal and Installation (If
Equipped)
Removal
1) Disconnect negative (–) cable at battery.
2) Remove front bumper, and then remove front
bumper guard from front bumper referring to "Front
Bumper and Rear Bumper Components in Section
9K".
3) Disconnect coupler from fog light.
4) Remove fog light screws (1), and remove front fog
light (2).
1
2
Installation
Reverse removal procedure for installation nothing the
following:
• After installing, adjust aiming referring to "Front Fog
Light Aiming Adjustment with Screen (If Equipped)".

Front Fog Light Bulb Replacement (If Equipped)

WARNING
!
• To avoid danger of being burned, don't
touch when the bulb is hot.
• Don't touch glass surface of bulb to avoid
deteriorate as the case may be unclear
when bulb light on at dirty condition.
1) Remove front bumper referring to "Front Bumper
and Rear Bumper Components in Section 9K".
2) Remove fog light bulb (1) as shown.
1
3) Replace fog light bulb and assemble all removed
parts.

Front Fog Light Switch Inspection (If Equipped)

NOTE
S7RS0B9206014
Front fog lights light up only when headlight
switch is in HEADLIGHT position (low or high
beams) or SMALL position. Front fog lights
turn OFF automatically when headlight
switch is turned to OFF position. If front fog
light switch holds ON position, front fog
lights turn ON automatically when headlight
switch is tuned to HEADLIGHT position (low
or high beams) or SMALL position again.
Check for continuity between terminals at each switch
position. If check result is not as specified, replace
switch.
I6RS0C920003-01
Switch Position
ON (PUSH IN)
S7RS0B9206015

Front Fog Light Relay Inspection (If Equipped)

1) Check that there is no continuity between terminals
"3" and "4". If there is continuity, replace relay.
2) Connect battery positive (+) terminal to terminal "2"
of relay.
3) Connect battery negative (–) terminal to terminal "1"
of relay.
4) Check continuity between terminals "3" and "4". If
there is no continuity when relay is connected to the
battery, replace relay.
I4RS0A920020-01
Lighting Systems:
1
2
3
4
5
Terminal
2 3
OFF
"3"
"1"
"2"
"4"
9B-11
S7RS0B9206016
1
5 4
I4RS0A920021-01
S7RS0B9206017
I4RS0A920022-01