Suzuki Swift Sport 2004 Service & Repair Manual page 864

5C-12 Clutch:
2) Install release shaft.
3) Apply grease to No.2 bush (1) inside and press-fit it
using the same special tool as in removal.
"A": Grease 99000–25011 (SUZUKI Super
Grease A)
Special tool
(A): 09922–46010
4) Coat grease to release shaft seal (2) lip and then
install it till it is flush with case surface. Use special
tool for this installation and face seal lip downward
(inside).
"A": Grease 99000–25011 (SUZUKI Super
Grease A)
Special tool
(B): 09925–98221
5) Caulk seal at A using caulking tool and hammer.
6) Apply grease to release bearing inside and release
shaft (2), then set release bearing (1).
"A": Grease 99000–25011 (SUZUKI Super
Grease A)
7) Apply small amount of grease to input shaft (3)
spline (0.3 g (0.01 oz)) and front end (0.15 g (0.005
oz)) as well.
"B": Grease 99000–25210 (SUZUKI Super
Grease I)
8) Set release arm (1) to release shaft (2) aligning
punch mark (4) of release arm and punch mark (3) of
release shaft, then tighten bolt to specified torque.
Tightening torque
Release lever bolt (a): 23 N·m (2.3 kgf-m, 17.0 lb-
ft)
I3RM0A530017-01
2
4
(a) 3
I4RS0A530021-01
1
I4RS0A530022-01