Suzuki Swift Sport 2004 Service & Repair Manual page 723

Step
2 Check TCC solenoid valve circuit for IG short
1) Connect valve body harness connector.
2) Disconnect TCM connectors.
3) Check for proper connection to TCM at terminal "C34-3"
and "C34-5".
4) If connection is OK, turn ignition switch ON and measure
voltage between terminal "C34-3" of disconnected
harness side TCM connector and ground between
terminal "C34-5" of disconnected harness side TCM
connector and ground.
Are voltage 1 V or less?
3 Check TCC lock-up pressure control solenoid valve
resistance
1) Turn ignition switch OFF.
2) Disconnect valve body harness connector (1), (2) on
automatic transaxle.
3) Check for proper connection to solenoid at "WHT/BLU"
and "WHT/BLK" circuits.
4) Check resistance of TCC lock-up pressure control
solenoid valve.
TCC lock-up pressure control solenoid valve
resistance
Between terminals of transaxle side valve body
harness connector: 5.0 – 5.6 Ω at 20 °C (68 °F)
Between terminals of transaxle side valve body
harness connector and transaxle: Infinity
Is check results satisfactory?
Action
2
5 4 3 2 1
10 9 8 7 6
Automatic Transmission/Transaxle:
Go to Step 3.
Intermittent trouble or
faulty TCM.
Check for intermittent
trouble referring to
"Intermittent and Poor
Connection Inspection
in Section 00".
If OK, substitute a
known-good TCM and
recheck.
1
I4RS0A510020-01
Yes
"WHT/BLU" or "WHT/
BLK" circuit shorted to
power circuit.
Replace TCC lock-up
pressure control
solenoid valve or lead
wire.
5A-79
No