Front Disc Brake Pad Inspection; Front Disc Brake Caliper Removal And Installation - Suzuki Swift Sport 2004 Service & Repair Manual

2) Set brake pad springs (1), shim (2) and install brake
pads (3).
NOTE
Install right side brake pad with wear
indicator (4) to vehicle center side.
3) Install caliper and tighten caliper pin bolts (a) to
specified torque.
Tightening torque
Caliper pin bolt (a): 26 N·m (2.6 kgf-m, 19.0 lb-ft)
(a)
4) Install wheel and lower lift.
5) Tighten wheel nuts to specified torque.
Tightening torque
Wheel nut (a): 85 N·m (8.5 kgf-m, 61.5 lb-ft)
6) After completion of installation, check for brake
effectiveness.

Front Disc Brake Pad Inspection

Check pad lining for wear. When wear exceeds limit,
replace with new one.
CAUTION
!
Never polish pad lining with sandpaper. If
lining is polished with sandpaper, hard
particles of sandpaper will be deposited in
lining and may damage disc. When pad lining
requires correction, replace it with a new one.
Front brake pad thickness (lining thickness)
Standard: 10 mm (0.40 in.)
Limit: 2 mm (0.08 in.)
NOTE
When pads are removed, visually inspect
caliper for brake fluid leak. Correct leaky
point, if any.
I6RS0C420002-01
Front Disc Brake Caliper Removal and
Installation
Removal
1) Hoist vehicle and remove wheel.
2) Loosen flexible hose joint bolt (1) a little at caliper.
CAUTION
!
Be careful not to twist flexible hose while
loosening the bolt.
I4RS0A420002-01
3) Remove caliper pin bolts (1).
S7RS0B4206004
4) Remove caliper from caliper carrier.
5) Disconnect flexible hose from caliper using care not
to twist it. As this will allow brake fluid to flow out of
flexible hose, have a container ready beforehand.
Front Brakes:
1
4B-3
I2RH01420005-01
S7RS0B4206005
I6RS0C420003-01
I2RH01420010-01