A/T Fluid Change; Select Lever Components; Select Lever Assembly Removal And Installation; Select Lever Knob Installation - Suzuki Swift Sport 2004 Service & Repair Manual

5A-90 Automatic Transmission/Transaxle:

A/T Fluid Change

CAUTION
!
Do not use any fluid other than the specified
ATF. Use of any fluid other than the specified
ATF may cause juddering or some other
faulty condition to occur.
1) Lift up vehicle.
2) When engine is cool, remove drain plug (1) from
transaxle housing (2) and drain A/T fluid.
3) Install drain plug (1).
Tightening torque
A/T fluid drain plug (a): 17 N·m (1.7 kgf-m, 12.5
lb-ft)
4) Lower vehicle and pour proper amount of SUZUKI
ATF 3317 or Mobil ATF 3309.
5) Check fluid level referring to "A/T Fluid Level Check".
Automatic transaxle fluid
: SUZUKI ATF 3317 or Mobil ATF 3309
Automatic transaxle fluid capacity
When draining from drain plug hole: 3.3 liters
(6.97 / 5.81 US/Imp. pt.)
When overhauling: 5.6 liters (11.83 / 9.86 US/Imp.
pt.)
1. Fluid level gauge 3. "LOW HOT" mark
2. "FULL HOT" mark 4. "FULL COLD" mark

Select Lever Components

S7RS0B5106003
Select Lever Assembly Removal and
Installation
I3RM0B510033-01
Remove and install select lever referring to "Select Lever
Components." When installing select lever noting the
following.
• After installing select lever, adjust select cable
referring to "Select Cable Adjustment".

Select Lever Knob Installation

Screw select lever knob onto select lever by specified
numbers of rotation below.
Rotation numbers for select lever knob installation
(a): 11 – 12 rotations
I3RM0B510032-01
5. "LOW COLD" mark
1
2
1. Shift lock solenoid
2. Select lever assembly
CAUTION
!
When installing select lever knob, do not turn
more than specified numbers of rotation.
Otherwise select lever knob is damaged.
S7RS0B5106004
4
3
I4RS0A510052-01
3. Connector
4. "3" position switch
S7RS0B5106005
S7RS0B5106006
1,(a)
I4RS0B510006-01