Select Cable Adjustment; Key Interlock Cable Removal And Installation - Suzuki Swift Sport 2004 Service & Repair Manual

Select Cable Adjustment

1) Shift manual shift lever to "N" range (transmission
range sensor "N" range).
"R" "N" "D"
"P"
2) Remove adjuster (cable end) from select lever pin of
select lever assembly.
3) Release lock plate (1) which restrict moving of cable
end holder (2).
4) Push cable end holder (1) out from eye-end (2) using
an appropriate tool (3) to disengage cable.
5) Shift select lever to "N" position.
6) Apply grease to select lever pin and install adjuster
(cable end) to it.
: Grease 99000–25011 (SUZUKI Super Grease
A)
7) With both select lever and transmission range
sensor kept each "N" position, drive cable end holder
(1) in until it locks cable.
8) Slide lock plate (2) to secure cable end holder in
position.
S7RS0B5106013
"2"
"L"
I3RM0B510036-01
I2RH01510046-01
I2RH01510047-01
Automatic Transmission/Transaxle:
9) After select cable was installed, check for the
following.
• Push vehicle with select lever shifted to "P" range.
Vehicle should not move.
• Vehicle can not be driven in "N" range.
• Vehicle can be driven in "D", "3", "2" and "L"
ranges.
• Vehicle can be backed in "R" range.

Key Interlock Cable Removal and Installation

NOTE
Don't bend interlock cable excessively when
removing and installing it, or system will not
operate correctly.
Removal
1) If the vehicle is equipped with air bag system,
disconnect negative cable at battery and disable air
bag system, referring to "Disabling Air Bag System in
Section 8B".
2) Remove steering column cover.
3) Turn ignition switch to ACC position.
4) Pull out key interlock cable (1) from key cylinder
cover (2) while pressing check hook with slotted
screwdriver (3) or the like.
2
5A-93
I3RM0B510037-01
S7RS0B5106014
3
1
I2RH01510083-01