Rear Wiper Relay Removal And Installation; Rear Wiper Relay Inspection; Specifications - Suzuki Swift Sport 2004 Service & Repair Manual

Rear Wiper Relay Removal and Installation

Removal
1) Disconnect negative (–) cable at battery.
2) Remove junction block assembly referring to "BCM
(Included in Junction Block Assembly) Removal and
Installation in Section 10B".
3) Remove rear wiper relay.
Installation
Reverse removal procedure for installation.
Tightening Torque Specifications
Fastening part
Washer tank bolt
Windshield wiper bolt
Windshield wiper arm nut
Rear wiper motor mounting bolt
Rear wiper nut
Rear wiper arm nut
NOTE
The specified tightening torque is also described in the following.
"Wipers and Washers Components"
Reference:
For the tightening torque of fastener not specified in this section, refer to "Fasteners Information in Section 0A".

Rear Wiper Relay Inspection

S7RS0B9406012
1) Check that there is no continuity between terminal
"3" and "4". If there is continuity, replace relay.
2) Connect battery positive (+) terminal to terminal "2"
of relay.
3) Connect battery negative (–) terminal to terminal "1"
of relay.
4) Check continuity between terminal "3" and "4". If
there is no continuity when relay is connected to the
battery, replace relay.

Specifications

Tightening torque
N⋅m kgf-m
4
8
16
8
5
8
Wipers / Washers:
"3"
"1"
"2"
"4"
lb-ft
0.4 3.0
0.8 6.0
1.6 11.5
0.8 6.0
0.5 4.0
0.8 6.0
9D-10
S7RS0B9406013
I4RS0A940028-01
S7RS0B9407001
Note