Suzuki Swift Sport 2004 Service & Repair Manual page 1129

CAUTION
!
• Be sure to perform "Air Bag Diagnostic System Check" before starting diagnosis according to flow.
• When measurement of resistance or voltage is required in this flow, use a tester along with a correct
terminal adapter from special tool (Connector test adapter kit).
• When a check for proper connection is required, refer to "Inspection of Intermittent and Poor
Connections".
• If there is open circuit in the air bag wire harness, connector or terminal is found damaged, replace
the wire harness, connector and terminal as an assembly.
DTC Will Set when
The voltage measured at side curtain-air bag (driver or passenger) initiator circuit is above a specified value for
specified time.
Flow Test Description
Step 1: Check whether malfunction is in side curtain-air bag (inflator) module.
Step 2: Check side curtain-air bag initiator circuit.
DTC Troubleshooting
Step
1 1) With ignition switch OFF, remove rear side upper trim of
driver or passenger side and disconnect side curtain-air
bag (inflator) module connector.
2) Check proper connection to side curtain-air bag (inflator)
module at terminals in "L18" or "L41" connector.
3) If OK, then connect special tools (A), (B) and (C) to side
curtain-air bag (inflator) module connector.
Special tool
(A): 09932–76010
(B): 09932–75010
(C): 09932–78310
4) Check SDM DTC.
With ignition switch ON, is DTC B1364 or B1368 still
indicated?
Action
"L18", "L41"
(C)
(A)
STEERING WHEEL
Go to Step 2.
(B)
I7RS0A820032-04
Air Bag System:
Yes
Replace side curtain-air
bag (inflator) module
referring to "Side
Curtain-Air Bag
(Inflator) Module
Removal and
Installation".
8B-91
No