Rear Brake Disc Removal and Installation
Removal
1) Hoist vehicle and remove wheel.
2) Remove caliper assembly by removing caliper
carrier bolts (1) (2 pcs).
CAUTION
!
During removal, be careful not to damage
brake flexible hose and not to depress brake
pedal.
NOTE
Hang removed caliper with a wire hook or the
like so as to prevent brake hose from
bending and twisting excessively or being
pulled.
Don't operate brake pedal with brake pads
removed.
1
3) Pull brake disc off by using 8 mm bolts (1) (2 pcs).
Installation
S7RS0B4306008
Install in reverse order of removal nothing the following.
• Tighten brake disc screws and caliper carrier bolts to
• Tighten wheel nuts to specified torque.
• Upon completion of installation, perform brake test.
Rear Brake Disc Inspection
• Using magnetic stand and with dial gauge positioned
I6RS0C430014-01
Rear brake disc deflection
Limit: 0.10 mm (0.004 in.) max.
Special tool
1
(A): 09900–20607
(B): 09900–20701
1
I6RS0C430017-01
specified torque.
Tightening torque
Caliper carrier bolt (a): 60 N·m (6.0 kgf-m, 43.5 lb-
ft)
(a)
Tightening torque
Wheel bolt: 85 N·m (8.5 kgf-m, 61.5 lb-ft)
at about 10 mm (0.39 in.) inward from periphery of
disc, measure deflection of disc.
If limit value is exceeded, replace correct or replace.
Rear Brakes:
4C-9
I6RS0C430015-01
S7RS0B4306009
(B)
(A)
I6RS0B431031-01