Blower Speed Selector Inspection
Check blower speed selector for each terminal to
terminal continuity. If check result does not meet the
following conditions, replace HVAC control unit.
I
GND
Terminal
GND
Position
OFF
1
2
3
4
Air Intake Selector Inspection
• Check that there is continuity between terminal (1)
and terminal (2) when air intake selector is at fresh
position.
• Check that there is no continuity between terminal (1)
and terminal (2) when air intake selector is at
recirculation position.
If check result does not meet the above conditions,
replace HVAC control unit.
1
2
S7RS0B7106010
H
MH
L
ML
I
L
ML
MH
I4RS0A710019-01
S7RS0B7106011
I5RS0A710001-01
Air Intake Control Actuator Removal and
Installation
Removal
1) Remove instrument panel from vehicle body
referring to "Instrument Panel Removal and
Installation in Section 9C".
2) Remove screws (1).
3) Remove air intake control actuator (2) from HVAC
unit.
H
1
Installation
Reverse removal procedure noting the following
instruction.
• Be sure to insert the linkage pin (1) into the groove (2)
of air intake control actuator.
Heater and Ventilation:
S7RS0B7106012
1
2
I4RS0A710021-01
1
2
I4RS0A710022-01
7A-9