Suzuki Swift Sport 2004 Service & Repair Manual page 118

1A-68 Engine General Information and Diagnosis:
DTC Troubleshooting
NOTE
• When measuring circuit voltage, resistance and/or pulse signal at ECM connector, connect the
special tool to ECM and/or the ECM connectors referring to "Inspection of ECM and Its Circuits".
• Upon completion of inspection and repair work, perform "DTC Confirmation Procedure" and
confirm that the trouble has been corrected.
Step
1 Was "Engine and Emission Control System Check"
performed?
2 MAP sensor and its circuit check
1) Connect scan tool to DLC with ignition switch OFF.
2) Turn ignition switch ON.
3) Check intake manifold pressure displayed on scan tool.
Is it 127 kPa (37.5 in.Hg)?
3 MAP sensor power supply voltage check
1) Disconnect connector from MAP sensor with ignition
switch turned OFF.
2) Check for proper connection of MAP sensor at "GRY/
RED", "RED/BLK" and "ORN" wire terminals.
3) Turn ON ignition switch, measure voltage between
engine ground and "GRY/RED" wire terminal of MAP
sensor connector.
Is voltage 4 – 6 V?
4 MAP sensor power supply circuit check
1) Disconnect connectors from A/C refrigerant pressure
sensor (if equipped with A/C) with ignition switch turned
OFF.
2) Turn ON ignition switch, measure voltage between
engine ground and "GRY/RED" wire terminal of MAP
sensor connector.
Is voltage 4 – 6 V?
5 MAP sensor ground circuit check
1) Measure resistance between "ORN" wire terminal of
MAP sensor connector and engine ground with ignition
switch turned OFF.
Is resistance below 5
Action
Ω
?
Yes
Go to Step 2.
Go to Step 3.
Go to Step 5.
I4RS0B110019-03
Faulty A/C refrigerant
pressure sensor (if
equipped with A/C).
Go to Step 7.
No
Go to "Engine and
Emission Control
System Check".
Intermittent trouble.
Check for intermittent
referring to "Intermittent
and Poor Connection
Inspection in Section
00".
Go to Step 4.
"GRY/RED" wire is open
or shorted to power
circuit.
Go to Step 6.