Table of Contents
Advertisement
0B-8 Maintenance and Lubrication:
Brake Fluid Inspection
1) Check around master cylinder and reservoir for fluid
leakage. If found leaky, correct.
2) Check fluid level.
If fluid level is lower than the minimum level of
reservoir, refilling is necessary. Fill reservoir with
specified brake fluid.
For the details, refer to "Brake Fluid Level Inspection
in Section 4A".
CAUTION
!
Since brake system of this vehicle is factory-
filled with brake fluid indicated on reservoir
tank cap, do not use or mix different type of
fluid when refilling; otherwise serious
damage will occur.
Do not use old or used brake fluid, or any
fluid from an unsealed container.
Brake fluid
Refer to reservoir cap of brake master cylinder.
Brake Fluid Replacement
Change brake fluid as follows.
Drain existing fluid from brake system completely, fill
system with specified fluid and carry out air purge
operation.
For air purging procedure, refer to"Air Bleeding of Brake
System in Section 4A".
Brake Lever and Cable Inspection
1) Inspect brake cable for damage and smooth
movement.
Replace cable if it is in deteriorated condition.
S7RS0B0206035
2) Check tooth tip of each notch for damage or wear. If
any damage or wear is found, replace parking lever.
3) Check parking brake lever for proper operation and
stroke, and adjust it if necessary.
For checking and adjusting procedures, refer to
"Parking Brake Inspection and Adjustment in Section
4D".
Parking brake lever stroke
"a": 4 – 9 notches (with 200 N (20 kg, 44 lbs) of pull
pressure)
I7RW01020002-01
Clutch Fluid Inspection
S7RS0B0206017
1) Check clutch system for evidence of fluid leakage.
Repair leaky point if any.
2) Check reservoir for fluid level referring to "Clutch
Fluid Level Inspection in Section 5C".
If fluid is lower than minimum level of reservoir, refill
reservoir with specified brake fluid indicated on
reservoir cap.
S7RS0B0206018
I4RS0A020009-01
I4RS0B020005-01
S7RS0B0206019
I4RS0A410006-01
Hide quick links:
Advertisement
Chapters
Table of Contents
