1E-2 Engine Lubrication System:
Oil Pressure Check
WARNING
!
To avoid danger of being burned, do not
touch exhaust system when it is still hot.
NOTE
Prior to checking oil pressure, check the
following.
• Oil level in oil pan
If oil level is low, add oil up to Full level
mark (hole) (1) on oil level gauge referring
to "Engine Oil and Filter Change in Section
0B".
2. Low level mark (hole)
• Oil quality
If oil is discolored or deteriorated, change
it. For particular oil to be used, refer to
"Engine Oil and Filter Change in Section
0B".
• Oil leaks
If leak is found, repair it.
Diagnostic Information and Procedures
S7RS0B1504001
I2RH0B150002-01
1) Remove front bumper referring to "Front Bumper
and Rear Bumper Components in Section 9K".
2) Remove engine front cover (1).
3) Disconnect oil pressure switch coupler (1).
4) Remove oil pressure switch (2) from cylinder block.
5) Install special tools (oil pressure gauge) to vacated
threaded hole of oil pressure switch.
Special tool
(A): 09915–77310
(B): 09915–78211
1
I4RS0A150001-01
I2RH0B150003-01
I2RH0B150004-01