Suzuki Swift Sport 2004 Service & Repair Manual page 33

Severe
condition code
– B – – E – – H Automatic transaxle fluid
– – C D – – – – HVAC air filter (if equipped) *2
NOTE
• "I": Inspect and correct or replace if necessary
• "R": Replace or change
• *1: Inspect or replace more frequently if the vehicle is used under dusty conditions.
• *2: Clean or replace more frequently if the air from the air conditioning decreases.
Accessory Drive Belt Inspection
WARNING
!
All inspection and replacement are to be
performed with ENGINE NOT RUNNING.
Water Pump and Generator Drive Belt
1) Disconnect negative (–) cable at battery.
2) Inspect belt for cracks, cuts, deformation, wear and
cleanliness. If any defect exists, replace.
Check belt for tension.
Water pump and generator belt tension
"a": 4.5 – 5.5 mm (0.18 – 0.22 in.) deflection
under 100 N (10 kg, 22 lb) pressure
NOTE
When replacing belt with a new one, adjust
belt tension to 3.5 – 4 mm (0.14 – 0.16 in.)
3) If belt is too tight or too loose, adjust it to
specification by adjusting alternator position.
4) Tighten alternator adjusting bolts and pivot bolt.
5) Connect negative (–) cable to battery.
Maintenance
Repair Instructions
S7RS0B0206001
I3RM0A020001-01
Maintenance and Lubrication:
Maintenance
operation
Every 30,000 km (18,000 miles) or
R
24 months
Every 15,000 km (9,000 miles) or 12
I
months
Every 45,000 km (27,000 miles) or
R
36 months
A/C Compressor Drive Belt
1) Disconnect negative (–) cable at battery.
2) Inspect belt for cracks, cuts, deformation, wear and
cleanliness. If any defect exists, replace.
Check belt for tension.
If belt tension is out of specification, adjust it
referring to "Compressor Drive Belt Inspection and
Adjustment in Section 7B".
A/C compressor drive belt tension
"a": 7 – 8 mm (0.28 – 0.31 in.) deflection under
100 N (10 kg, 22 lb) pressure
NOTE
When replacing belt with a new one, adjust
belt tension to 6 – 7 mm (0.24 – 0.28 in.).
3) Connect negative (–) cable to battery.
Maintenance interval
I4RS0A020001-01
0B-3