Knock Sensor Removal And Installation; Main Relay, Fuel Pump Relay And Starting Motor Control Relay Inspection - Suzuki Swift Sport 2004 Service & Repair Manual

1C-10 Engine Electrical Devices:

Knock Sensor Removal and Installation

Removal
1) Disconnect negative (–) cable at battery.
2) Hoist vehicle.
3) Remove right side drive shaft referring to "Front
Drive Shaft Assembly Removal and Installation in
Section 3A".
4) Disconnect knock sensor connector (1).
5) Remove knock sensor (2) from cylinder block.
Installation
Reverse removal procedure for installation.
Tightening torque
Knock sensor (a): 22 N·m (2.2 kgf-m, 16.0 lb-ft)
1
Main Relay, Fuel Pump Relay and Starting Motor
S7RS0B1306016
Control Relay Inspection
1) Disconnect negative (–) cable at battery.
2) Remove main relay (1), fuel pump relay (3) and/or
starting motor control relay (2) from individual circuit
fuse box No.1.
3) Check that there is no continuity between terminal
"C" and "D". If there is continuity, replace relay.
4) Connect battery positive (+) terminal to terminal "B"
of relay. Connect battery negative (–) terminal to
terminal "A" of relay. Check for continuity between
terminal "C" and "D". If there is no continuity when
relay is connected to the battery, replace relay.
2, (a)
I3RB0A130007-01
3
"C"
"A"
"B"
"D"
S7RS0B1306017
2
1
I4RS0A130014-01