Suzuki Swift Sport 2004 Service & Repair Manual page 115

DTC Confirmation Procedure
NOTE
Check to make sure that the following conditions are satisfied when using this "DTC Confirmation
Procedure".
• Intake air temperature at engine start: –10 °C (14 °F) to 80 °C (176 °F)
• Intake air temperature: –10 °C (14 °F) to 70 °C (158 °F)
• Engine coolant temperature: 70 °C (158 °F) to 150 °C (302 °F)
• Altitude (barometric pressure): 2400 m, 8000 ft or less (560 mmHg, 75 kPa or more)
1) Connect scan tool to DLC with ignition switch OFF.
2) Turn ON ignition switch and clear DTC using scan tool and warm up engine completely.
3) Increase engine speed up to 2000 rpm or more for 10 seconds.
4) Run engine at idle speed for 1 min.
5) Check DTC and pending DTC.
DTC Troubleshooting
NOTE
• When measuring circuit voltage, resistance and/or pulse signal at ECM connector, connect the
special tool to ECM and/or the ECM connectors referring to "Inspection of ECM and Its Circuits".
• Upon completion of inspection and repair work, perform "DTC Confirmation Procedure" and
confirm that the trouble has been corrected.
Step
1 Was "Engine and Emission Control System Check"
performed?
2 MAP sensor and its circuit check
1) Connect scan tool to DLC with ignition switch turned
OFF.
2) Turn ON ignition switch.
3) Check DTC.
Is there DTC P0107 or DTC P0108?
3 MAP sensor output signal check
1) Check MAP sensor according to "MAP Sensor
Inspection in Section 1C".
Is it in good condition?
4 MAP sensor circuit check
1) Check MAP sensor circuit referring to Step 3 to 6 of
"DTC P0107: Manifold Absolute Pressure / Barometric
Pressure Circuit Low Input" or Step 3 to 8 of "DTC
P0108: Manifold Absolute Pressure / Barometric
Pressure Circuit High Input".
Is circuit in good condition?
5 Air intake system check
1) Check air intake system for clog or leak.
Is it in good condition?
Action
Engine General Information and Diagnosis:
Yes
Go to Step 2.
Go to applicable DTC
diag. flow.
Go to Step 4.
Go to Step 5.
Substitute a known-
good ECM and recheck.
1A-65
No
Go to "Engine and
Emission Control
System Check".
Go to Step 3.
Faulty MAP sensor.
Repair or replace.
Repair or replace.