Suzuki Swift Sport 2004 Service & Repair Manual page 190

1A-140 Engine General Information and Diagnosis:
DTC Confirmation Procedure
1) With ignition switch turned OFF, connect scan tool to DLC.
2) Turn ON ignition switch and clear DTC.
3) Make sure that all accessory switch is tuned OFF.
4) Start engine and warm it up to normal operating temperature (ECT approx. 90 – 95 °C, 193 – 203 °F).
5) Turn ON following accessory switch.
• Head lights switch.
• Blower motor switch (max position).
• Rear defogger switch.
6) Increase engine speed to 4000 rpm and keep it for 10 sec. or more.
7) Decrease engine speed to idle.
8) Check DTC.
DTC Troubleshooting
NOTE
• When measuring circuit voltage, resistance and/or pulse signal at ECM connector, connect the
special tool to ECM and/or the ECM connectors referring to "Inspection of ECM and Its Circuits".
• Upon completion of inspection and repair work, perform "DTC Confirmation Procedure" and
confirm that the trouble has been corrected.
Step
1 Was "Engine and Emission Control System Check"
performed?
2 Generator control circuit check
1) Disconnect connector from generator and ECM with
ignition switch turned OFF.
2) Check for proper connection of wire terminal to
generator connector and to ECM connector.
3) If connections are OK, check generator control
(generator "C" terminal) circuit and field coil monitor
(generator "FR" terminal) circuit for the following.
• Resistance of each generator control wire and field
coil monitor wire between generator connector and
ECM connector is less than 1 Ω (continuity check)
• Resistance between generator control wire and field
coil monitor wire of generator connector is infinity
(insulation check)
• Resistance between each generator control wire and
field coil monitor wire of generator connector and
vehicle body ground is infinity (ground circuit short
check)
• Voltage between each generator control wire and field
coil monitor wire of generator connector and vehicle
body ground is 0 V with ignition switch tuned ON
(power circuit short check)
Are they in good condition?
3 Generator check
1) Check for generator output referring to "Generator Test
(Undercharged Battery Check) in Section 1J" and
"Generator Inspection in Section 1J".
Is check result satisfactory?
Action Yes
Go to Step 2.
Go to Step 3.
Substitute a known
good ECM and recheck.
No
Go to "Engine and
Emission Control
System Check".
Repair or replace
defective wire.
Repair or replace
generator.